3.4.23 Displaying GPS Reception Status (GPS Status)
The reception status of GPS(GPS/DGPS/WAAS) which is connected to radar processor unit is
displayed.
This setting is enabled when a JRC’S GPS/DGPS/WAAS is connected to the GPS connector of
processor unit.
Procedures 1. Press the [STBY] key.
The transmission standby state is activated.
2 Press the [RADAR MENU] key twice.
3 Open the GPS Status menu by performing the following menu
operation.
4. NAV equipment Setting
→ 4. GPS Status
This window cannot be opened in the transmission state.
4. After check of the GPS status, press [0] key to close the GPS status
window.
3-47
To Next Page
Loading...
