3.10.2 Load Operating State (Load User Setting)
The operating state saved in the system can be loaded by performing the operation below.
When the operating state is loaded, the previous operating state data is discarded. Therefore, if you
do not want to discard the operating state data, save the operating state by performing the operation
described in Section 3.10.1.
Procedures 1 Put the cursor on the display item switching (Brilliance / Alarm â‘ on
page 2-28), and press the [ENT] key.
The Brilliance menu and the Display INFO menu are switched.
2 Put the cursor on the user setting load (Display information ⑦
on
page 2-28), and press the [ENT] key.
The Load User Setting menu will appear.
3 Press numeric keys corresponding to the file to be loaded.
Confirmation Window will appear.
4 Press the [1] key.
The operating state data will be loaded.
3.10.3 Delete Operating State (Delete User Setting)
The operating state saved in the system can be deleted by performing the operation
below.
Use this function to delete unnecessary operating state data.
Procedures 1 Press the [RADAR MENU] key twice.
2 Open the Delete User Setting menu by performing the following menu
operation.
5. Sub Menu
→ 3. User Setting
→ 3. Delete User Setting
3 Press numeric keys corresponding to the file to be deleted.
Confirmation Window will appear.
4 Press the [1] key.
The operating state data will be deleted.
3-103
To Next Page
Loading...
Need help?
General
