3.11 USING CARD ........................................................................................ 3-104
3.11.1 OPERATE FILE ON THE CARD (FILE MANAGER) ........................ 3-104
3.12 DISPLAY SIMPLE CHART .................................................................... 3-110
3.12.1 DISPLAY JRC COASTLINE ROM CARD [MAP] ............................. 3-110
3.12.2 DISPLAY ERC CARD [MAP]............................................................ 3-110
3.12.3 DISPLAY JRC CHART ON CF CARD
(SEL JRC ROM CARD FILE) ...........................................................3-111
3.12.4 FILL CHARTS (FILL LAND AREA).................................................. 3-112
3.12.5 SET JRC / ERC CHART DISPLAY (JRC / ERC SETTING) .............. 3-113
3.12.6 DISPLAY C-MAP CARD [MAP]........................................................ 3-117
3.12.7 CORRECTING CHART POSITION (MAP DISPLAY SETTING)....... 3-120
3.12.8 CHART PLOTTING BEARING MODE (MAP DRAW AZI MODE) .... 3-122
3.13 CAPTURE SCREEN TO CARD............................................................. 3-123
3.13.1 SAVE SCREEN TO CARD ............................................................... 3-123
3.13.2 AUTOMATICALLY SAVE SCREEN TO CARD................................. 3-123
3.13.3 ERASING SAVE SCREEN DATA..................................................... 3-124
3.13.4 SET SAVE ITEMS ............................................................................ 3-125
3.13.5 SET FILE STYLE ............................................................................. 3-125
3.13.6 OPEN THE CAPTURED SCREEN FILE .......................................... 3-126
3.14 RECEIVE PORT SETTING.................................................................... 3-128
3.14.1 RECEIVE PORT SETTING (RX PORT)............................................ 3-128
4. MEASUREMENT OF RANGE AND BEARING
4.1 USE OF NAVIGATION TOOLS.................................................................. 4-1
4.1.1 USING CURSOR (CURSOR) ............................................................... 4-2
4.1.2 USING RANGE RINGS [RR / HL] ........................................................ 4-2
4.1.3 USING ELECTRONIC BEARING LINE (EBL1/EBL2) ......................... 4-3
4.1.4 USING VARIABLE RANGE MARKER (VRM1 / VRM2) ....................... 4-6
4.1.5 USING PARALLEL INDEX LINES (PI MENU)...................................... 4-7
4.1.6 OPERATING EBL MANEUVER FUNCTION
(EBL MANEUVER SETTING)........................................................... 4-12
4.1.7 USING MOB [MOB] ........................................................................... 4-14
4.1.8 OPERATING EBL, VRM, AND PI WITH CURSOR............................. 4-14
4.2 MEASUREMENT OF RANGE AND BEARING ....................................... 4-17
4.2.1 MEASUREMENT WITH CURSOR POSITION (CURSOR)................. 4-18
4.2.2 MEASUREMENT WITH ELECTRONIC BEARING LINE
AND VARIABLE RANGE MARKER [EBL] [VRM]............................ 4-19
4.2.3 MEASUREMENT WITH TWO ARBITRARY POINTS......................... 4-20
To Next Page
Loading...
