3－70
JMA-7100 Instruction Manual > 3.BASIC OPERATION > 3.7 USE ROUTE FUNCTION
4) To add another Waypoint, repeat procedure 3.
5) To finish adding a Waypoint, left-click twice at the last Waypoint.
The Waypoint adding mode is cancelled.
(Example)
3.7.2.3 Correcting coordinates of a Waypoint (Correct Position)
The coordinates of a Waypoint in the route data saved in the radar system are corrected.
Procedures
1) Open the Set Route Sequence menu by performing the menu
operation below.
→
→
2) Left-click the button.
The Waypoint correcting mode is selected.
3) On the radar display, put the cursor on the Waypoint that is to
have its coordinates corrected, and left-click.
The Waypoint to be corrected is specified.
The cursor display becomes a cursor mark, and a rubber band is displayed.
062T
12.0kn
Last Waypoint
Rubber ban
023
024
Route
2. WPT/Route Setting
3. Set Route Sequence
3. Correct Position
To Next Page
Loading...
