JRC JMR-9225-9X3 - Setting up Alerts; Collision Avoidance Alert Generation Conditions; New Target Warning Generation Conditions; Depth;Safety Contour Alert Generation Conditions

2.11 Switching the Transmission Pulse Length
1 Click the transmission pulse witch changeover button of the radar system information.
Each time the button is clicked, the transmission pulse witch changes.
Example: "MP1"→"MP2"→"LP1"→"LP2"
2.12 Switching the Azimuth Mode
1 Click the Azimuth Mode button of the presentation and mode information.
2 Select the azimuth mode from "N UP", "H UP", "C UP", "C UP(Angle Setting)" and "W
UP".
The azimuth mode switches.
* [W UP] is in a state in which to load the route,
motion mode is displayed only in the case of [RM (T)] or [RM (R)].
Azimuth Mode Button
Transmission Pulse Width
Changeover Button
15