JRC JQE-103 - Chapter 2: Installation; Component Checking; Installation Cautions

2-1
2
CHAPTER 2. INSTALLATION
This unit must be installed by the dealer or service person.
Therefore, this chapter provides only general information related to the system.
For detailed information about the system, please refer to the Installation Manual.
NOTE
Refer the Installation manual for the detail of installation.
The selector switch is set to “READY” position at factory.
Do not turn the selector switch to “ON” unless in case of emergency.
Fig.2 Selector switch
2-1 Checking of the components
After unpacking, check for all the components listed in Section 1-3 “Configuration”.
2-2 Caution of installation
(1) The Satellite EPIRB must be installed in a place where it is not directly exposed to waves and the
automatic release bracket can smoothly be operated.
(2) The Satellite EPIRB must be installed in a place where works and passing are not prevented and the
Satellite EPIRB can easily be operated.
(3) The Satellite EPIRB must be installed vertically.
(4) The automatic release bracket contains a magnet. The magnetic compass and so forth must be put
apart from the automatic release bracket 2 meters or more so that it is not influenced.
(5) The Satellite EPIRB must be installed in a place where it is hard to be stolen.
Selector switch
A
ntenna
Indicator lam
p
WARNING