JRC JQE-103 - Power OFF Procedure; Power Off Procedure

3-2
Be sure to return the stopper to the original position after the selector switch was set.
Fig.3-1b Reset of the Stopper
3-2 Power OFF
Confirm that the selector switch is set to “READY” (If not, set it to “READY”), and take the Satellite EPIRB out
of water. Then the Satellite EPIRB stops its activation.
Fig.3-2 Power off
Stopper
Stopper pin
Selector switch
A
ntenna
Stopper pin
Stoppe
r
Selector switch