7
Enter your Access Code. The Entry Tone should stop and you should check the display for any
further messages. Under normal circumstances the display will now return to “SYSTEM OPEN”.
The system is now Unset (i.e.Open).
Important Note
Always check the display after entering your Access Code in case there has been an Alarm
Activation while the system was Set (it could well be that the audible warnings have timed out).
You may need to enter additional keystrokes to clear the message list.
In some system layouts you can reach the Remote Keypad without starting the Entry Tone. In that
case enter your Access Code; the Entry Tone will commence and the “ENTER CODE” message
will appear after the first keystroke. Now complete the Access Code, this will stop the Entry
Tone. Now check the display for any further messages. Under normal circumstances the display
will revert to “SYSTEM OPEN” as above. The system is now Unset (i.e.Open).
Part Set
Use Part Set when parts of the building (e.g. bedrooms) will still be occupied; Part Set mode will
automatically omit those Zones which are to be excluded. The Exit/Entry route parameters are
changed during Part Set so that you still have access to the Remote Keypad from the unset area.
Proceed as for Full Set only using the [PART] key instead of the [FULL] key ; providing the system
is OK there will be a Night Setting Tone (a soft clicking sound) and the display will read:-
If the system has a Setting Fault the Fault Tone will sound and the same rules apply as for Full Set.
Once Residential Setting Tone is established proceed to the unprotected area. The Night Setting
Tone should stop 2 seconds after the Part Set Exit Timer has timed out. If there is a Fault Tone
immediately after the Exit Timer has elapsed you may have a fault in the Exit/Entry Route; if this
does not clear after a few seconds you will need to cancel the Exit Procedure and investigate the
fault.
Cancelling the Exit Procedure
During Exit Tone you can return to “SYSTEM OPEN” by re-entering your Access Code.
Unsetting
When you return to the protected area via the Exit/Entry route you will normally be picked up by
a detector; this will start the Entry Tone which signifies that you must Unset the system within a
pre-determined time limit. Proceed directly to the nearest Remote Keypad which will display the
message:-
To Next Page
Loading...