− 5 −
1
Pin
A
2. HOW TO REMOVE THE SEWING TABLE
(1) When replacing the bobbin thread
1
Move the clamp foot to the rear end of its
stroke.
2
Insert your ngers into notches
A
in the bottom
of right- and left-hand sewing tables
1
and
2
,
and push up the sewing tables.
3
Move the tables in the direction of the arrow
keeping the above state, and you can see the
bobbin case.
At this time, move the sewing tables so as
not to allow the sewing tables to come in
contact with the needles.
4
After replacing the bobbin thread, return the
sewing tables in place by following the above-
mentioned steps of procedure in the reverse
order. Now, rmly set the sewing tables on the
throat plates and the pins.
2
CAUTION
:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
To Next Page
Loading...
