JUKI CP-170 - 8. NEEDLE UP;DOWN COMPENSATION SWITCH

- 10 -
ENGLISH
Every time needle up/down compensation switch
1
is pressed, the needle goes up when it is in its lowest
position or comes down when it is in its highest position.
This compensates the stitch by a half of the
predetermined stitch length
However, note that the machine does not run
continuously at a low speed even if you keep the switch
held pressed.
Also, note that the needle up/down compensation switch
is inoperative after turning the handwheel by hand.
Sewing of needle up/down compensation operation does
not make the thread trimming operation operative.
8. NEEDLE UP/DOWN COMPENSATION SWITCH
Whenever pressing the needle up/down compensation
switch
1
and turning ON the power to the machine, the
stop position when the pedal is in its neutral position can
be changed over.
Also, the specied state at this time can be conrmed at
the control box.
(The contents shown there will be reected when turning
ON the power after next time.)
2
• Control box
The needle bar stops
in the lowest position
of its stroke
The needle bar stops
in the highest position
of its stroke