JUKI LBH-1702 - Page 70

− 70 −
23) Cloth cutting knife (solenoid) motion time (Memory switch No. 24)
This switch can change the length of time during which the cloth cutting knife solenoid is held ON. (SA
and SB types)
24) Cloth cutting knife (cylinder) motion time (Memory switch No. 25)
This switch can change the length of time during which the cloth cutting knife cylinder is held ON. (SC
type)
25) Presser-up drive waiting time (Memory switch No. 26)
This switch can change the waiting time from the start of detection of the needle-up position of the last
stitch to the drive of the auto-lifter.
26) Stop-motion solenoid ON timing (Memory switch No. 27)
This switch can change the timing (waiting angle) from the upper dead point of one stitch before the
last stitch to the drive of the stop-motion solenoid. (SA type)
27) Stop-motion solenoid action time (Memory switch No. 28)
This switch can change the length of time during which the stop-motion solenoid is heled ON. (SA
type)
28) Start-up waiting time (Memory switch No. 32)
This switch can change the time from turning ON the start switch to the start of the sewing machine.
29) Active tension variation compensation (Memory switch No. 55)
This switch can compensate the tension value of the active tension.
24 50
ms
25
80
ms
ms26 50
27
360
˚
28 50
ms
ms
32 60
55
0