– 53 –
4) Change data of selected editing point.
Press DATA CHANGE key
and data of editing point can be changed.
Pattern No. which has been registered is displayed and it is possible to select.
In addition, press RESET key
, and the pattern data of editing point can be deleted.
When RESET key
is held pressed for one second, all the registered pattern data can be delet-
ed.
Repeat steps
3)
and
4)
to perform editing data.
5) Cancelling insertion of the pattern data.
When RESET key
is pressed while the addition command pictograph is displayed, insertion of
the pattern data can be cancelled.
In addition, when READY key
is pressed, insertion of the pattern data is cancelled and the
mode changes over to the sewing mode.
When RETURN key
is pressed, insertion of the pattern data is cancelled and the mode changes
over to the input mode.
6) Creating new pattern data
Press COPY key
, under the input mode, to call the copy screen. Then, press ITEM SELECT key
to select the new-creation pictograph. This enables the creation of new pattern data.
When you press DATA CHANGE key
while the new-creation pictograph is being selected, the
pattern number to be newly created can be selected.
Then, select the pattern number to be newly created and press READY key
to create new
pattern data.
1) Putting the data name in the edit state.
Refer to
"V-17. Performing continuous stitching" p.48
and
"V-18. Performing cycle stitching"
p.51
.
2) Changing the name of data.
Refer to
"V-11. Changing sewing data" p.35
.
19. How to change the name of cycle/continuous sewing data
To Next Page
Loading...
