8-10. Adjusting the brightness of the hand lamp
1
7
6
4
5
The brightness of the hand lamp can be adjusted on
the operation panel.
1) Select the memory switch operation mode.
Refer to
"13. MEMORY SWITCH" p.95
for how
to operate the memory switch operation mode.
2) Press – key
4
or + key
5
to display
memory switch No. 30.
3) Press BACK key
6
or FORWARD key
7
to change the set value.
The brightness can be set to one of 20 steps from
0 (total extinction) to 100 (maximum). The bright-
ness has been factory-set to 100 (maximum) at
the time of shipment.
After the completion of the adjustment of bright-
ness to an appropriate value, press READY key
1
to confirm the setting. Then, exit the
memory switch operation mode.
Hand lamp
To Next Page
Loading...
Need help?
General
