– 16 –
^
.
ADJUSTING THE SEWING MACHINE
1. Adjusting the silicon container thread guide
1) Loosen setscrews
1
. Fix setscrews
1
with shifted
to the lowermost position.
2) Loosen setscrew
2
. Adjust so that the center of
screw is spaced 29 mm away from the center of the
needle thread guide rod. Then, x setscrew
2
.
29 mm
2
1
3) Loosen setscrews
3
and adjust so that the heights
of the respective needle thread guide rods are the
dimensions as shown in the table. Then tighten
screws
3
to x the thread guide rods.
A B C
29 mm 17 mm 5 mm
2. Adjusting the needle bar thread take-up thread receiver
1
2
3
Loosen setscrew
1
and adjust so that the bottom end
to the center of the thread hole of needle bar thread
take-up
3
aligns with the top end of needle bar thread
take-up thread receiver
2
when the needle bar is in its
lowest position. Then tighten screw
1
to x the needle
bar thread take-up thread receiver.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the fol-
lowing work after turning the power off and ascertaining that the motor is at rest.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the fol-
lowing work after turning the power off and ascertaining that the motor is at rest.
A
B
C
3
To Next Page
Loading...
