JUKI MO-1000 - Needle and Thread

19
Needle and thread /
机针和缝线
Needles
Needles must be in perfect condition.
Problems can occur if needles:
A are bent.
B are damaged or blunt.
C have hooked points.
A
B
C
Needle and thread
The needle size used depends on the thread. The needles should be in accor-
dance with thread used.
When sewing, the thread is fed through the long groove in the needle. If the
needle is too ne, the thread does not t into the groove and stitches will be
skipped.
Use needles No. 70 - 90.
* It is recommended to use JLx2 needle, especially when sewing thick materi-
als, overlapped section, etc, with overlock machine.
机针和缝线
机针的型号取决于缝线。机针大小应该与缝线粗细相符。
在缝纫时，缝线会穿过机针上的针孔。如果机针太细的话，缝线将无法穿过针
孔或引发跳线。
机针型号为 Mo.70-90。
*推荐使用 JLx2 机针，特别是缝制厚料时，几层叠起的重叠部位以及包缝等
工序时较适宜。
机针
机针必须是完好无损。
机针如果发生如下问题则有可能会引
发故障 ：
A弯曲。
B机针破损或是针尖磨损。
C有毛刺。