Inserting needles
Needles can be inserted quickly and easily with the practical cleaning
brush and needle inserter (A).
• Switch the machine off (Power switch to “0”).
• Disconnect machine from electricity supply.Turn the handwheel to-
wards you until needles are fully raised.
• Lower the presser foot.
Using the small screwdriver, loosen the needle setscrews and remove
the needles (B). Place the right hand needle, flat side towards the
back, into the hole of the needle inserter and insert the needle as far
as possible into the needle clamp. Tighten the setscrew lightly and then
insert the lefthand needle in the same way and tighten both setscrews
(C).
Using the machine
Needle and machine
Your overlock machine is equipped with needle system 130/705 H
(household sewing machine needles). These should be purchased
when replacement needles are required. Use needles no. 70 - 90 on
your machine.
11
To Next Page
Loading...
