Adjustments and settings
Presser foot pressure
The presser foot pressure is factory adjusted to a medium setting.
Should you wish to adjust it, simply turn the knob in the direction de-
sired:
Position of knob for normal pressure (A)
More pressure: for thick or stiff fabrics such as denim, tweed, rm linen
(B)
Less pressure: for lightweight or sheer fabrics and knits (C).
Settings and practical sewing
Thread breakage during sewing
Sew off immediately at an angle and remove the work. Re-thread. If the
lower looper thread has broken, cut off both needle threads at the nee-
dles and remove the thread. First thread the looper then the needles.
Start sewing again about 2-3 cm in front of where the thread broke.
Unpicking seams
Using sharp scissors, cut the loops (C). Pull the needle thread (D) and
the stitches will come undone.
24
To Next Page
Loading...
