JUKI MO-6000G Series - Installing Position of the Needle Clamp; (Applicable Only to MO-6.616 S; MO-6916 R, G, J Series)

,11
!I
:-1
;ii
II
I
1l
Ii
I
'I
!1
'I
11
~
'!i
I
Standard Adjustment
(3) Installing position of the needle clamp
Needle clamp connecting stud O should fit with the bottom end of needle bar 8 or spaced within o to
0.5mm.
Oto 0.5 mm
Butt the needle clamp with the
bottom
end of the needle bar.
0
( 4) Adjusting the length of the lower looper holder
(Applicable only to M0-6~ 16S / M0-6916R, G, J series)
The center-to-center distance should be 26 mm.
At this time, the clearance between the end surface of the arm and the neck of the ball should be
3.5mm.
26mm
-10 -
From the Library of Superior Sewing Machine & Supply LLC