JUKI MO-6000G Series - (Applicable Only to M0-6~ 16 S;MO-6916 R, G, J Series); Returning Amount of the Double Chain Looper; Longitudinal Motion {Avoid Motion); Clearance between the Double Chain Looper and the Needle

Standard Adjustment
(9) Adjusting the double chain looper
(Applicable only to M0-6.616S/6916R, G, J series)
1) Returning amount of the double chain looper
The distance between the needle center and the blade point of the double chain looper should be 1.5
to 2 mm when the_ looper is at the extreme left of its travel.
M0-691 SG, J series
M0-66165
1
R series
2) Longitudinal motion (Avoid motion)
The standard minor axis of the elliptical motion should be :
3.0 mm (M0-6~ 16S, R).
3.5 mm (M0-691 BG, J).
•
(63.4mm)
Note : The avoid motion should be adjusted in accordance with Needle No.
__ ,.,---------\
Marller (\. I
l-~ ~j
3) Clearance between the double chain looper and the needle
The clearance should be 0.05 to 0.1 mm.
o.os to o. 1 mm
-20-
Marker Hole 8
From the Library of Superior Sewing Machine & Supply LLC