JUKI MO-6000G Series - Upper Looper; Center-To-Center Distance of the Upper Looper Holder; Caution in Assembly; Application of Sealant

(3) Center-to-center distance of the upper looper holder
The center-to-center distance of upper looper holder O.
•
(Caution) * (asterisk) marks are exclusive for
to the MO-6900G(J). They are not
common to the MO-6000S(R) series.
( 4) Caution in assembly
1) Application of sealant
Model
MO- _ 6604S(R) -t::.6.b
-666.
MOSS
-Ab.6
-A~O
MO- 6604S(R) -004 to OE4 4ti.H
.
OF6 50H
MO- 6612S
-CE4 -40H
MO· 6612S
-D66
-D.66
rvD- 6~14S(A) -~
-61:..6
MO- 6616S(R) ~
-1.:..li.O
BE4
MO· 6616S{R)- 0D6 to FFt::.-
4
61-1
561-l
MO- 6943R -Mb. -6D.7
MO- 6M3S
-~
-40H
MO- 6903G -ON6
-3D1
MO- 6904G(J) -OF6
-700
700
MO- 6905G
·OMS
-
7E0
MO- 6914G(J) -CH6
-700
FH6
MO- 6916G (J) -
FF6
-700
(Unit: mm)
Center-to-center distance C)
38
39
38
39
39
38
39
39
39
•39
37.5
•39
37.5
37.5
G) Setscrew of the throat plate base (B) retainer 8 (JUKI seal)
~1~~e Apply only to
'y~ _, the right
Apply the sealant only to the right setscrew.
•7 c,_(~ setscrew
® Bottom surface of the upper looper guide support 8 (Three-bond 1104)
Apply the sealant to the bottom surface of the upper looper guide support 8, which contacts with the
frame surface.
@ After assembling the front edge of the upper looper guide support e (Three-bond 1212), apply the
sealant to the gap of the contact surface between the frame and the upper looper guide support O
( Offlffl section in the illustration).
Be careful not to allow the
sealant to run to the rear.
Apply the sealant to
bottom surface.
-69-
Apply the sealant to the
bottom surface.