JUKI MO-6800S Series - Lubrication and Drainage; Lubrication Oil Procedures; Draining and Refilling Oil

– 8 –
4-1. Lubrication oil
4. LUBRICATION AND DRAINAGE
1) Remove oil sight window
❶
from the oil inlet. Add lubricating oil specically made for machines which run
at a super-high speed (JUKI MACHINE OIL #18) supplied with the unit or equivalent through the oil inlet.

When the oil surface reaches the space between two marker lines on the oil gauge, tighten oil sight window
❶
.
2) (Only for the MO-6800S) Before using a new sewing machine for the rst time after the purchase or the
sewing machine which has not been used for an extended period of time, the shaded sections of needle
bar
❷
and upper looper guide
❸
have to be lubricated.
Take care not to pour too much amount of lubricating oil at the time of lubrication. If the ma-
chine is lubricated with an excessive amount of oil, oil leakage can be caused.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power o󰀨 and ascertaining that the motor is at rest.
❶
4-2. Drainage and rell the oil
1) Loosen the screw
❶
and drain all the oil inside
the oil tank. Then, tighten the screw
❶
again.
2) In order to extend the term of usage, please re-
place the oil after the rst four weeks, and then
replace it every four months.
❶
❷
❸
* Only for the MO-6800S * Only for the MO-6800S