– 1 –
1. This product cuts the material using the Level 4 no observation light continuous wave laser.
Wave length is 10.6 μm, maximum output is 100 W and the angle is 3.1 mrad. Only the per-
sons who have received professional training are allowed to use and handle this product.
Be sure to contact our After-Sale Service staff if you want to carry out maintenance and / or
repair of this product. Professional staff who has received professional training in JUKI to
gain experience of the relevant work will carry out maintenance / repair of your product.
1. SAFETY PRECAUTIONS
2. Whenever you use of this product or carry out maintenance / repair of it, be sure to wear
safety goggles. Use the safety goggles that satisfy the following criteria or that are provided
by the manufacturer.
Safety goggles selection criteria :
1. CE Marking is obtained
2. Visible light transmittance VLT>60%
3. Applicable wave length : 10.6μm
4. Protective characteristics : Light absorption type CO2 laser safety goggles or light reflec-
tion type CO2 laser safety goggles
5.Protection level : OD5+
3. Safety-mark attachment positions and meaning of icons and expressions
For the PS-800-8045 models
Avoid direct exposure or
disperse exposure of the
eyes and skin to radia-
tion.
Avoid direct exposure
or disperse exposure of
the eyes and skin to ra-
diation. This product is
a Class 4 laser product.
Be careful about the
laser.
To Next Page
Loading...
Need help?
General