JUKI SC-510 Engineer's Manual

− 9 −
(3) Press switch 3 or switch 4 and
select the reverse stitching pattern.
Reverse stitching patterns and displays are as
follows.
: Reverse stitching
: Double reverse stitching
: Without reverse stitching
(4) Press / switch 1 to make reverse
stitching at end display 7 flash on and off, and set
the pattern in the same way as step (3).
[ Setting procedure of the reverse stitching ]
(1) Hold pressing / switch 1, and press
/ switch 2 to select the reverse
stitching pattern.
(Every time / switch 2 is pressed,
reverse stitching pattern/overlapped stitching
pattern change over alternately.)
(2) Press / switch 1 to make reverse
stitching at start display 6 flash on and off.
Every time / switch 1 is pressed, the
flashing position shifts in the right direction.
(Caution) The sewing machine does not start
in the flashing state.
Operating procedure of the sewing pattern
1. Reverse stitching pattern
Reverse stitching patterns below can be set by using the operation panel.
Reverse stitching patterns that can be set
Reverse stitching
at start display
Sewing pattern
A
Overlapped stitching pattern
Reverse stitching pattern
B
D
C
D
C
A
B
A
B
B
A
D
C
D
C
A
B
A
B
A
B
D
C
D
C
D
C
D
C
D
C
A
B
A
B
1
2
1
2
1
Shift direction
Flash
Contents of reverse
stitching slection
updating with swith3
3
4
⇔
7
6
7
6
Flash
updating with swith4
1
Reverse stitching
at end display

JUKI SC-510 Specifications

General

Brand	JUKI
Model	SC-510
Category	Sewing Machine
Language	English