– 44 –
bb
bb
b
Touch back switch 1 needle compensation function (Function setting No. 105)
When the IP-100 is connected and a corner pattern is selected in this condition, this function is used to perform
compensation sewing in the middle of in-corner sewing with the use of the touch back switch.
0: off Compensation sewing disabled with the touch back switch
1: on Compensation sewing enabled with the touch back switch
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
nn
nn
n
Presser lifter switch 1 needle compensation function (Function setting No. 106)
When the IP-100 is connected and a corner pattern is selected in this condition, this function is used to perform
compensation sewing in the middle of in-corner sewing with the use of the presser lifter switch.
0: off Compensation sewing disabled with the presser lifter switch
1: on Compensation sewing enabled with the presser lifter switch
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
* When using this function, it is necessary to set up the presser lifter function selection (No.117) at 0 (function
disabled).
mm
mm
m
In-Corner sewing one-shot function (Function setting No. 107)
When the IP-100 is connected and a corner pattern is selected in this condition, this function is used to perform
automatic one-shot sewing in the middle of in-corner sewing.
0: off Automatic one-shot sewing disabled during in-corner sewing
1: on Automatic one-shot sewing enabled during in-corner sewing
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
,,
,,
,
In-corner presser lifter function (Function setting No. 108)
When the IP-100 is connected and a corner pattern is selected in this condition, this function is used to perform
automatic presser rising after the completion of in-corner sewing.
0: off Automatic presser rising disabled after the completion of in-corner sewing
1: on Automatic presser rising enabled after the completion of in-corner sewing
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
* This function is available only if the automatic presser lifter unit (AK) is connected.
105
0
106
1
107
0
108
1
To Next Page
Loading...
Need help?
General
