– 47 –
¶¶
¶¶
¶
Selection of presser lifter switch function (Function setting No. 117)
In the condition when the knee switch is connected, this function is used to select [stop or use] of the automatic
presser lifter function by means of the knee switch.
0: off The automatic presser lifter is stopped with the knee switch.
1: on The automatic presser lifter is used with the knee switch.
*Setting is possible only if LH-4168 or LH-4188 is selected for the machin
*When using this function, it is necessary to set up the presser lifter switch 1 (No.106) at 0 (function disabled).
••
••
•
Grease up error reset (Function setting No. 118)
When a grease-up error (E220, E221) occurs, this error can be reset by setting the setup description at 1.
0: Normal condition
1: Grease-up error reset when the power is turned on for the next time
(After grease-up error has been reset, this function is also canceled.)
*Prior to resetting the grease-up error, grease-up treatment is always needed.
* Setting is possible only for the machine head (part of the LH-4100 or LH-3500 Series) where grease-up treat-
ments are needed.
117
0
118
0
To Next Page
Loading...
Need help?
General
