JUKI TL-98Q - 15. Drop-feed knob

– 14 –
15. Drop-feed knob
Disassembly
™ Set 1 drop-feed knob to "NOT
FEED", remove 4 drop feed knob
shaft setscrew, and remove 3 E-
ring of drop feed knob.
™ Remove 2 DF adjusting arm
spring while removing 6 DF
adjusting arm asm..
Assembly
™ Pass 1 drop feed knob through
5 wire installing plate.
™ Assemble 2 DF adjusting arm
spring while assembling 6 DF
adjusting arm asm..
™ Place 3 E-ring to 1 drop feed
knob.
™ Assemble drop feed knob shaft
with 4 setscrew.
Point
™ It is easy to remove 2 spring
when 1 drop-feed knob is set to
“NOT FEED” side.
3 E-ring
5 Wire installing plate asm.
2 DF adjusting arm spring
6 DF adjusting arm asm.
1 Drop-feed knob
4 Drop feed knob shaft setscrew