Need help?Do you have a question about the JUKI TL-98E and is the answer not in the manual?
General| Brand | JUKI |
|---|---|
| Model | TL-98E |
| Category | Sewing Machine |
| Language | English |
Sets dimension from throat plate to needle bar bushing lower end face (64.8±0.1mm).
Aligns needle bar's upper engraved line with needle bar bushing lower end face.
Adjusts clearance between throat plate and presser foot to 7.0±0.5 mm.
Sets feed dog height relative to throat plate (1.2±0.1 mm protrusion).
Aligns needle top with throat plate at 0±0.2 mm clearance during feed timing.
Aligns needle bar line with bushing end and hook point with needle center.
Adjusts clearance between needle and hook blade point to 0.05-0.1 mm.
Sets clearance between inner hook and bobbin case finger (0.6-0.8 mm).
Adjusts thread take-up spring tension to 0.127-0.157N during lowering.
Sets thread take-up spring absorbing amount to 10.5±0.5 mm.
Adjusts moving knife position by moving the installing plate.
Sets solenoid position for close contact of roller arm with knife arm.
Sets thread trimmer cam timing by aligning cam contact shaft with groove.
Adjusts looper position and moving amount for proper contact.
Adjusts thread tension disk open/close by setting wire setscrew nut.
To Next Page
