– 12 –
15. Drop-feed knob
Disassembly
Set drop-feed knob 1 to “NOT
FEED” and remove drop-feed
adjusting arm spring 2.
Remove E-ring 3 of knob shaft.
Remove knob shaft setscrew 4 and
draw out drop-feed knob.
Assembly
Pass drop-feed knob through wire
installing plate 5 on frame and enter
E-ring.
Insert drop-feed adjusting arm asm.
6, press it to E-ring 3, remove the
play and tighten it with setscrew 4.
Point
It is easy to remove spring 2 when
drop-feed knob 1 is set to “FEED”
side.
3
5
2
6
44
1
14. Hand lifter lever
Disassembly
Enter 3 to 4 screw threads of M4
screw (arm cover setscrew) in the
hole of hand lifter lever shaft on
frame.
Hold screw head and draw out the
screw. At the same time, hand lifter
lever shaft 2 is drawn out.
Remove hand lifter lever 1.
Assembly
Enter hand lifter lever shaft 2 into
the hole on frame.
Tap head of lever shaft to fit the shaft
by force and set the shaft to hole in
hand lifter lever.
Point
End face of lever shaft that is fit by
force should not be convex from
frame face.
1 Hand lifter lever
2 Hand lifter lever shaft
3 M4 screw
To Next Page
Loading...
