Julabo DYNEO DD - Original Operating Manual

96 pages

Save Page as PDF

To Next Page

Heating immersion circulators, heating circulators with open

baths, refrigerated circulators

Original operating manual

1.950.1300.us.V03 05/2022

Main Page

Table of Contents3
Foreword7
About this Manual8
Original JULABO Spare Parts8
Accessories8
Warnings9
Symbols Used10
Intended Use10
Safety11
General Safety Instructions for the Operating Company11
General Safety Instructions for the Operator11
General Safety Instructions for Device Operation12
Safety Symbols13
Safety Function13
Product Description15
Product Overview15
Function Description15
Operating and Functional Elements16
Interfaces17
Connection of Pt100 Temperature Sensor17
RS232 Interface (Optional)18
Analog Interfaces (Option)19
Alarm Output19
REG/EPROG Socket20
Standby Input21
Operating Interface22
Operation with the Central Controller23
Softkeys and Status Icons23
Alarm Messages24
Operator Messages25
Main Menu26
Settings Menu26
Record Data Menu26
Thermodynamics Menu27
Adjust Safety Menu27
Programmer Menu27
Menu Connect Unit28
Service Menu28
Install Unit Menu28
Technical Data29
Material of Parts that Come into Contact with the Medium31
Technical Data for Refrigerated Circulators32
Bath Fluids43
Hoses44
Transport and Installation45
Transporting the Device45
Install the Device at the Operating Location46
Initial Operation47
Connect the Device to the Power Supply47
Connect Bridge Mounted or Heating Circulator47
Connect Refrigerated Circulator48
Connecting an External System49
Connect an External System with Screw Connections50
Connect an External System with Barbed Fittings51
Switch on the Device and Set the Language53
Set High Temperature Safety Function53
Fill Device54
Set up Power Supply for the Refrigerated Circulator55
Adjusting the Flow of the Bath Fluid55
Set Chiller Mode56
Set Limit Values57
Set Temperature Warning Limits57
Adjusting Setpoint Limits57
Adjusting Actual Value Limits58
Band Limit for External Control58
Setting Band Limit59
Connect External Temperature Sensor59
Operation60
Switch on the Unit60
Switch off the Unit60
Start Temperature Control Application60
Basic Settings61
Set Language61
Set Date and Time61
Activate Autostart Function62
Set Physical Units62
Set Key Tones62
Record Data63
Record Measurement Data63
Reading out Blackbox Data63
Displaying Alarm Memory64
Thermodynamics64
Control Parameter64
Optimizing Temperature Curves65
Adjust Controller66
Limit Cooling Capacity and Heating Capacity66
Adjust Pump67
Remote Control Device67
Remote Control Device Using USB Interface67
Set RS232 Interface Parameters68
Remote Control Device Using RS232 Interface68
Set EPROG Input69
Set External Setpoint Values69
Set up Actuating Variable70
Request Device Status70
Working with the Programmer70
Setting the Timer71
Creating and Editing a Temperature Control Profile71
Delete Temperature Control Profile72
Set Profile Timer73
Profile Series Setup73
Configure Signal Outputs74
Configure Signal Outputs of the REG/EPROG Plug74
Activating Stand-By Input74
Adjusting the Temperature Sensor (ATC)75
Adjust Internal Temperature Sensor75
Adjust External Temperature Sensor76
Device Reset77
Maintenance78
Replace Detachable Power Cord78
Check Safety Symbols78
Check the Functionality of High Temperature Cut-Off78
Test the Low Liquid Level Safety Function79
Emptying79
Clean Device80
Device Storage81
Technical Service81
Warranty82
Disposal85
Device Disposal85
Appendix86
Interface Commands86
IN Commands86
OUT Commands89
Status Commands91
Status Messages91
Alarms and Warnings92

Julabo DYNEO DD - Original Operating Manual

Table of Contents

Other manuals for Julabo DYNEO DD

Related product manuals