Need help?Do you have a question about the Julabo SW22 and is the answer not in the manual?
General| Brand | Julabo |
|---|---|
| Model | SW22 |
| Category | Laboratory Equipment |
| Language | English |
Details the features and technology of the SW22 and SW23 shaking water baths.
Provides guidelines for safe handling, environment, and usage of the unit.
Defines requirements for qualified personnel and proper usage of the water bath.
Instructions for environmentally friendly disposal of the unit according to WEEE directive.
Details compliance with relevant European directives for safety and EMC.
Outlines the warranty terms and conditions for JULABO products.
Provides specifications for SW22 and SW23 models, including temperature, dimensions, and power.
Covers safety standards, environmental requirements, and protection classes for the unit.
Defines the meaning of warning symbols like Danger, Warning, Caution, and Notice.
Explains the usage of 'Note!' and 'Important!' symbols for special information.
Lists essential safety precautions for connecting and operating the unit.
Provides guidelines for selecting a suitable installation site and mounting the unit.
Recommends suitable bath fluids and warns against using unsuitable or flammable liquids.
Instructions on how to fill the bath with liquid and how to drain it safely.
Explains how to use the liquid level/cooling set for water supply and counter cooling.
Lists available accessories like bath covers and cooling installations.
Details how to safely connect the unit to a power socket.
Explains how to display and adjust the desired working temperature.
Describes how to set high and low temperature warning limits for sample protection.
Details how to adjust the shaking speed of the water bath.
Explains how to set and use the electronic timer for operating time.
Instructions on how to enable or disable the shaking operation.
Explains how to control the circulator pump on SW23 models.
Details how to switch the temperature display between Celsius and Fahrenheit.
Explains how to calibrate the temperature sensor for accurate measurements.
Guides on configuring the unit for remote control via RS232 interface.
Details how to set Baudrate, Parity, and Handshake for data transmission.
Describes how to adjust and evaluate high/low temperature warning limits.
Covers safety precautions for fuse replacement and pump motor overload protection.
Explains the different audible signals (alarm, warning, time) and their meanings.
Explains how to use terminal programs and the command structure for remote operation.
Provides a comprehensive list of commands for controlling the water bath remotely.
Lists and describes the different status messages the unit can display.
Lists and explains various error messages that may appear during operation.
To Next Page