JUMO DICON 400 - Page 4

Contents
4 Data flow 19
5 Address tables 21
5.1 Process data
...............................................................................................
21
5.2 Setpoints
.....................................................................................................
23
5.3 Manual output
.............................................................................................
23
5.4 Controller parameters
................................................................................
24
5.5 Configuration
..............................................................................................
25
5.6 Limit comparators
......................................................................................
25
5.7 Analogue inputs
..........................................................................................
27
5.8 Outputs
........................................................................................................
28
5.9 Ramp and profile program function (only Type 703570/75)
....................
29
5.10 Profile controller (only Type 703580/85)
...................................................
29
5.11 System states (only Type 703580/85)
........................................................
29
5.12 Mathematics and logic module
.................................................................
31
5.13 Displays
.......................................................................................................
31
5.14 Real-time clock (only Type 703580/85)
.....................................................
31
5.15 Binary/logic functions
................................................................................
32
5.16 Interface
......................................................................................................
32
5.17 Program start with start data (only Type 703580/85)
..............................
33
5.18 Operating mode Manual with man. data (only Type 703580/85)
............
33
5.19 Transmit program (only Type 703580/85)
.................................................
33
5.20 Commands
..................................................................................................
34
5.21 Frequent setpoint programming
...............................................................
35
5.22 Process value via interface
.......................................................................
35
5.23 Instrument identification
...........................................................................
35
5.24 External relay module
................................................................................
36
5.25 Setting the clock (only Type 703580/85)
...................................................
37
6 Sample program 39