Need help?Do you have a question about the JUMO DICON 500 and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Display | LCD |
| Inputs | Analog, Digital |
| Input channels | Up to 4 |
| Output channels | Up to 4 |
| Outputs | Analog |
| Control type | PID |
| Communication | RS-485 |
| Power supply | 24 V DC |
| Protection class | IP20 |
| Storage temperature | -20 to +70 °C |
| Relative humidity | 90% (non-condensing) |
Lists error codes and their meanings.
Explains the CRC16 calculation method and its purpose.
Details interface settings like protocol type, data format, parity, stop bits, baud rate, address, and response time.
Describes how to read multiple data words from a defined address.
Explains the process for writing a single data word to a specific address.
Lists addresses, data types, access, and signal designations for various process data points.
Lists addresses and designations for setpoints W1 through W4.
Details addresses and designations for controller parameters across multiple sets.
Lists addresses and designations for various configuration settings.
Lists addresses and designations for limit comparator functions and settings.
Lists addresses and designations for analogue input configurations (E1-E4).
Lists addresses and designations for output signal configurations (A1-A6).
To Next Page