Need help?Do you have a question about the JUMO dTRON 304 and is the answer not in the manual?
Covers safety regulations, cable selection, and general wiring practices.
Shows detailed wiring diagrams for different instrument types and terminal strips.
Configures sensor input types, linearization, and signal scaling.
Sets controller type, control action, and tuning parameters.
Configures analog and binary outputs for control signals.
Assigns functions to binary inputs and limit comparators for logic.
Describes the process of automatically optimizing controller parameters.
Covers safety regulations, cable selection, and general wiring practices.
Shows detailed wiring diagrams for different instrument types and terminal strips.
Configures sensor input types, linearization, and signal scaling.
Sets controller type, control action, and tuning parameters.
Configures analog and binary outputs for control signals.
Assigns functions to binary inputs and limit comparators for logic.
Describes the process of automatically optimizing controller parameters.
General| Housing size | 96 x 96 mm |
|---|---|
| Input channels | 1 or 2 |
| Weight | Approx. 500 g |
| Display | LCD |
| Outputs | Relay |
| Supply voltage | 110 to 240 V AC, 48 to 63 Hz |
| Communication | RS485, Modbus RTU |
| Protection type | IP65 (front) |
| Output channels | 2 |
| Power supply | 110 to 240 V AC, 48 to 63 Hz |
| Protection class | IP65 (front panel) |
| Dimensions | 96 x 96 mm |
| Storage temperature range | -40 to 70 °C |
| Relative humidity | 10 to 90% (non-condensing) |
To Next Page
