Need help?Do you have a question about the JUMO dTRANS pH 02 and is the answer not in the manual?
Explains danger and caution symbols for safety.
Details electrical connections, safety, isolation, and component wiring.
Provides initial setup steps and demonstrates common configuration scenarios.
Step-by-step guides for 1, 2, and 3-point pH calibration.
Notes, general info, ways to start, options, and 1/2-point calibration.
Notes, info, requirements, ways to start, and zero point calibration.
Details calibration for Linear, pH, Conductivity, and Chlorine modes.
A table listing problems, causes, and actions for troubleshooting.
Explains danger and caution symbols for safety.
Details electrical connections, safety, isolation, and component wiring.
Provides initial setup steps and demonstrates common configuration scenarios.
Step-by-step guides for 1, 2, and 3-point pH calibration.
Notes, general info, ways to start, options, and 1/2-point calibration.
Notes, info, requirements, ways to start, and zero point calibration.
Details calibration for Linear, pH, Conductivity, and Chlorine modes.
A table listing problems, causes, and actions for troubleshooting.
General| Category | Controller |
|---|---|
| Measurement Range pH | 0 to 14 pH |
| Accuracy pH | ±0.01 pH |
| Accuracy Temperature | ±0.5 °C |
| Display | LCD |
| Protection Class | IP65 |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -20 to 70 °C |
| Input | pH, temperature (Pt100/Pt1000) |
| Output | 2 relay outputs, 0/4 to 20 mA |
| Power Supply | 24 V DC |
| Dimensions | 96 x 96 mm |
To Next Page