JUMO DICON 501 - Page 4

Contents
5 Operation 23
5.1 Displays and keys ....................................................................................... 23
5.2 Operating modes and states ..................................................................... 24
5.3 Principle of operation ................................................................................ 25
5.4 Entering values and selecting settings .................................................... 26
5.5 Operating modes ........................................................................................ 27
5.5.1 Basic status .................................................................................................. 27
5.5.2 Manual operating mode ............................................................................... 28
5.5.3 Automatic operating mode (program run) .................................................... 29
5.6 Shifting the setpoint ................................................................................... 30
5.7 Altering setpoints ....................................................................................... 30
5.8 Setpoint switching ..................................................................................... 31
5.9 Display switching ....................................................................................... 32
6Profile program start 33
6.1 Instant start of program ............................................................................. 33
6.2 Delayed start of program ........................................................................... 33
7Profile program editor 35
7.1 General ........................................................................................................ 35
7.2 Editing segments ........................................................................................ 37
7.3 Inserting segments .................................................................................... 38
7.4 Copying segments ..................................................................................... 38
7.5 Deleting segments ..................................................................................... 39
7.6 Programming repeat cycles ...................................................................... 39
7.7 Temporary alterations ................................................................................ 40