7
2 General information
2.1 Target group
This operating manual is intended for user, who want to use the paperless
recorder as a Modbus slave and read out data from a Modbus master (e.g.
PLC).
2.2 Interfaces
ex-factory The paperless recorder is equipped with several interfaces as a standard:
• Serial interface RS232 or RS485
• Serial interface RS232 (barcode scanner)
• Ethernet 10/100 MBit/s
• 2 USB host and 2 USB device interfaces
The serial and the ethernet interfaces serves for communication with a bus
system or PC. They can be used, for example, to read out the measured
values and/or instrument and process data from the paperless recorder. In
connection with the ethernet interface and a PC webbrowser, recorders can be
monitored via the internet. Two RS232 interfaces are available. Both interfaces
are to be considered as equal.
The USB interfaces are fitted on the front and the back and intended for the
operation with the setup program or the PCA communication software (PCC)
or for reading out data via the USB memory stick. Only use one USB host or
USB device interface at a time. Instruments with stainless steel fronts are not
equipped with USB interfaces on the front.
Extra code The paperless recorder is equipped with several interfaces as an option:
• PROFIBUS-DP interface
2.3 System prerequisites
The following items are required for interface operation:
• Connection line:
for RS232
Interface cable RS232 (9/9-pin): TN 00367735
Interface cable RS232 (9/25-pin): TN 00367736
for ethernet, e.g.
RJ 45 patch cable, CAT 5 or higher (cross over)
• Setup or evaluation program, e.g.
Setup program: TN 00468991
PC evaluation software PCA3000: TN 00431882
PCA communication software PCC: TN 00431879
JUMO SVS3000 Visualization: Data Sheet
700755
• PC or notebook
To Next Page
Loading...
Need help?
General
