11.14 EN
164
4.3 Replacing wheels
WARNING!
A truck tipover can cause accidents
In order to raise the truck, use only suitable lifting gear at the points specially provided
for this purpose.
X
Note the weight of the truck on the data plate.
X
Always use a jack with a minimum capacity of 10000 kg kg.
X
Raise the unladen truck on a level surface.
X
When raising the truck, take appropriate measures to prevent it from slipping or
tipping over (e.g. wedges, wooden blocks).
WARNING!
Falling wheels can cause injury
X
The wheels of the truck are very heavy. A single wheel can weigh up to 250 kg.
X
Always replace wheels with a suitable tool and protective equipment.
Dismantle the wheels
Requirements
– Prepare the truck for maintenance and repairs
(see "Identification points and data plates" on
page 38).
Tools and Material Required
–Jack
– Hard wooden blocks
– Mounting lever
– Torque wrench
Procedure
• Place the jack against the contact point.
Z Jack contact point, see "Tyre type" on page 33.
• Raise the truck.
• Support the truck with hard wooden blocks.
• Undo the wheel attachment (233).
• Disassemble the wheel, using a suitable mounting lever if necessary.
The wheel is now disassembled.
233
To Next Page
Loading...
