Dual pedal (optional equipment)
Requirements
– Truck prepared for operation, see page 86.
Procedure
Z
For trucks with a dual pedal the travel
direction is selected via the accelerator pedals
(118;116). When the driver leaves the truck,
the truck is automatically set to “Neutral”.
• Release the parking brake (63).
• Raise the fork carriage approx. 200 mm.
• Tilt the mast back.
• Apply the accelerator pedal (118) to travel
forward. The travel speed is governed by the
accelerator (118).
• Apply the accelerator pedal (116) to reverse.
The travel speed is governed by the
accelerator (116).
The truck travels in the direction selected.
Changing direction during travel
Procedure
• Set the travel direction switch (76) to the opposite direction while travelling.
• For the twin pedal version apply the accelerator pedal in the opposite direction to
the travel direction (116 or 118).
The truck decelerates until it starts to travel in the opposite direction.
Z
When the truck changes direction it can start travelling at high speed in the opposite
direction unless the accelerator pedal is released in time. Changing direction results
in braking deceleration.
91
10.20 en-GB
To Next Page
Loading...
Need help?
General
