To Next Page

To Previous Page

C 5

0706.GB

4.1 Moving a truck with a rotary seat (o) without its own power system

– Move the lever (4) to the left to the

“release spring-loaded accumulator

brake” position.

– Move the pump lever (5) up and down

until the spring loaded piston has

extended to the end (approx. 20 -

25 mm). The drive wheels are no

longer blocked / braked by the spring-

loaded brake. The foot brake however

remains fully functional.

Before the driver leaves the truck with

the spring-loaded brake released, the

truck must be prevented from

accidentally rolling away using suitable

means.

Before starting the truck again with power supply, the lever (4) must be reset to the

right in the “travel” position. The truck can only operate in the travel position.

5 Towing the truck

– Attach the tow rod / rope to the attachment coupling on the recovery truck and the

truck to be recovered.

– Disconnect the battery (note item 3!)

– Release the parking brake.

One person must be seated on the towed truck in order to steer. Tow away the truck

at creep speed.

As the steering auxiliary unit is not applied, additional effort is required to steer the

truck.

With electrical steering (o) the truck cannot be steered. Inform the manufacturer’s

service department to have the truck towed away.

C 5