Activating the brake
Procedure
• Use wedges to prevent the truck from moving.
• Remove the two M5x50 screws (68) from the brake (69).
CAUTION!
Open covers can cause injury and accidents
u
The covers (battery cover, side panels, drive compartment cover etc.) must be
closed during operation.
Install the front panel (14), see page 180.
The brake has been reactivated. The brake is now be applied without current.
WARNING!
Only return the truck to service when you have identified and rectified the fault.
110
04.19 en-GB
To Next Page
Loading...
Need help?
General
