Juniper AP12 - Power Requirements for AP12

Table 2: Specicaons for AP12 (Connued)
Parameter Descripon
Radio frequency (RF)
• 5 GHz radio—Supports 2x2:2SS 802.11ax MU-MIMO and SU-MIMO
• 2.4 GHz radio—Supports 2x2:2SS 802.11ax MU-MIMO and SU-MIMO
• 2.4-GHz or 5-GHz scanning radio
• 2.4-GHz Bluetooth® Low Energy (BLE) with omni antenna
Maximum PHY rate (maximum
transmit rate at the physical
layer)
• Total maximum PHY rate—1775 Mbps
• For the 5-GHz radio—1201 Mbps
• For the 2.4-GHz radio—574 Mbps
Maximum devices that each
radio supports
512
Power Requirements for AP12
The AP12 requests 12.9 W to provide wireless only funconality. The AP12 requires 802.3at power
when you use the PoE out funconality. The AP can provide 7 W of PoE out. If you don't need to use
PoE out, the AP can operate with full funconality using 802.3af power. You can use any of the
following opons to power on an AP12:
• Power over Ethernet Plus (PoE+) from an Ethernet switch
We recommend that you use an Ethernet cable with a maximum length of 100 m to connect the
access point (AP) to the switch port.
If you use an Ethernet cable that is longer than 100 m by placing an Ethernet PoE+ extender in the
path, the AP might power up, but the Ethernet link does not transmit data across such a long cable.
You might see the status LED blink yellow twice. This LED behavior indicates that the AP is unable to
receive data from the switch.
• PoE injector
9