Juniper AP12 - Mounting Brackets for AP12; Mount the AP12 on a Single-Gang Junction Box

NOTE: We recommend that you claim your access point (AP) before you install it. The claim code
is located on the rear of the AP and it might be dicult to access the claim code aer you mount
the AP. For informaon about claiming an AP, see "Claim a Juniper Access Point" on page 11.
Mounng Brackets for AP12
Table 3 on page 16 lists the brackets available for the AP12.
Table 3: Mounng Brackets for AP12
Part Number Descripon
APBR-WP1 Wall plate bracket for mounng the AP12 on a wall.
The bracket ships with the AP and is compable for
installaon on single-gang and double-gang juncon
boxes.
APBR-DS1 Desktop stand that you can order separately
Mount the AP12 on a Single-Gang Juncon Box
You can mount the AP12 on a single-gang juncon box by using the wall plate bracket (APBR-WP1) that
we ship along with the AP12.
To mount an AP12 on a single-gang juncon box:
1. Aach the wall plate to the single-gang juncon box, as shown in Figure 4 on page 17.
16