Need help?Do you have a question about the Juniper ISG 2000 and is the answer not in the manual?
General| Brand | Juniper |
|---|---|
| Model | ISG 2000 |
| Category | Security System |
| Language | English |
Steps to upgrade the ISG 2000 to support Intrusion Detection and Prevention.
How to configure IDP using NetScreen-Security Manager.
Covers initial preparations, console connection, and basic configuration settings.
Understanding and configuring security zones and interfaces.
Creating policies to permit or deny traffic between zones.
Overview of Intrusion Detection and Protection (IDP) functionality.
Configuring a route-based VPN tunnel between the ISG 2000 and a remote peer.
Procedure to reset the ISG 2000 to its factory default settings.
Instructions for cabling the ISG 2000 to the network.
Guidelines and methods for mounting the ISG 2000 in an equipment rack.
Description of components and LEDs on the front panel of the ISG 2000.
Description of components on the rear panel, including power supplies.
Procedures for removing and inserting interface modules.
Procedures for replacing the fan tray and its filter.
Steps for replacing AC and DC power supplies in the ISG 2000.
Physical dimensions and weight specifications for the ISG 2000.
Electrical requirements, power ratings, environmental operating conditions.
Pinout for console/modem ports and interface media types.
To Next Page