EasyManuals Logo

Juniper SRX345 How To Set Up

Juniper SRX345
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
How to Set Up Your SRX345 Services Gateway
8
Verify the Settings
Access http://www.juniper.net to ensure that you are connected to the Internet.
This connectivity ensures that you can pass trac through the services gateway.
If the page does not load, perform the following checks to see if you can identify
the problem:
Verify your configuration settings, and ensure that you have applied the
con figuration.
Check if the ISP-supplied device connecting your SRX Series device to the
Internet is turned on and working properly. Try turning it o and on again.
After you complete these steps, the SRX Series device can pass trac from any
trust port to the untrust port.
NOTE: With this step, you have successfully completed the initial
configuration, and your SRX345 Services Gateway is ready for use.
Change the Configuration Settings (Optional)
After you complete the initial setup configuration, you can access the J-Web
setup wizard by clicking Configure > Device Setup > Set Up. You can either
edit the existing settings or create a new configuration. If you choose to create
a new configuration, then all the current configuration in the services gateway
will be deleted.
Power O the Device
You can power o the device in one of the following ways:
Graceful shutdown—Press and immediately release the Power button.
Forced shutdown—Press the Power button, and hold it for 10 seconds.
After powering o a power supply, wait at least 60 seconds before turning it
back on.

Other manuals for Juniper SRX345

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX345 and is the answer not in the manual?

Juniper SRX345 Specifications

General IconGeneral
USB 2.0 ports quantity1
Ethernet LAN (RJ-45) ports8
Flash memory8000 MB
Internal memory4000 MB
CertificationFCC A, RoHS 2
Rack capacity1U
Heat dissipation420 BTU/h
Power consumption (typical)122 W
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)10 - 90 %
Routing protocolsBGP, CLNS, MPLS, OSPF, RIP-1, RIP-2
Supported network protocolsIPv4, IPv6
Firewall securityYes
Security algorithmsIPSEC, SSL/TLS
Networking standardsIEEE 802.1p
Ethernet LAN data rates10, 100, 1000 Mbit/s
Weight and Dimensions IconWeight and Dimensions
Weight4900 g
Dimensions (WxDxH)440.9 x 370.1 x 43.6 mm

Related product manuals