Juniper SRX4100 - Next Steps; Power off the Device; Reset the Configuration

To Previous Page

Juniper Networks, Junos, Steel-Belted Radius, NetScreen, and ScreenOS are registered trademarks of Juniper Networks, Inc. in the United States and other countries. The Juniper Networks Logo, the Junos logo, and JunosE are trademarks of Juniper

Networks, Inc. All other trademarks, service marks, registered trademarks, or registered service marks are the property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies in this document. Juniper Networks

reserves the right to change, modify, transfer, or otherwise revise this publication without notice. Part Number: 530-074091 Rev. 01, December 2016.

10. Log in as root and proceed with conﬁguring the settings based on your

requirements.

Power O the Device

To power o the device, press the Power switch on the rear of the device. After

powering o the device, wait at least 60 seconds before turning it back on.

Reset the Conﬁguration

Pressing and holding the RESET button for 5 seconds or more deletes all

conﬁgurations (backup conﬁgurations and rescue conﬁguration) on the device,

and loads and commits the factory conﬁguration.

Next Steps

For information on conﬁguring features on your services gateway, refer to the