To Next Page

To Previous Page

How to Set Up Your SRX550 High Memory Services Gateway

3. Conﬁgure the security topology:

a. Internet zone (Untrust)

b. Internal zones (Trust)

c. DMZ

4. Conﬁgure the security policy:

a. Licenses (Security services)

b. DMZ policy

c. Internet and internal policies

d. Remote VPN

5. Conﬁgure Network Address Translation:

a. Internal Source NAT

b. Internal Destination NAT

c. DMZ Destination NAT

6. Review the settings and click Apply Settings.

NOTE: Check the connectivity from the management device to the

SRX Series device. You might lose connectivity to the SRX Series device

if you have changed the internal zone IP. Click the URL for reconnection

instructions on the Conﬁrm & Apply page to reconnect, if required.

7. Click Done to complete the setup.

Conﬁgure the Device Using the Default Setup Mode

NOTE: Verify that the management device is connected to port 0/1 on

the services gateway before proceeding to the next step.

1. Conﬁgure the basic settings – device name, root account information, and

system time.

Juniper SRX550 Manual

Other manuals for Juniper SRX550