Juniper SSG 520M Security Policy

Juniper Networks SSG 520M and SSG 550M Security Policy
7
Interfaces
The SSG 520M and SSG 550M provide a number of interfaces:
• Four Ethernet autosensing interfaces (RJ-45) (Data Input, Data Output, Control IN, Status
OUT). These interfaces are network ports. Each port has two LEDs that indicate port status:
Table 3: SSG 520M and 550M Ethernet Port LEDs
Name
Color
State
Description
Status (left)
Green
Steady
Link up
Off
Link down
TX/RX (right)
Green
Blinking
Indicates that traffic is
passing through
Off
Indicates that no traffic is
passing through.
• Console port – RJ-45 serial port connector (Data Input, Data Output, Status IN, Control OUT).
This port allows initial access to the Command Line Interface (CLI).
• Modem port – RJ-45 serial port connector. Disabled in FIPS mode.
• Power interface: AC or DC.
• The module has four status LEDs:
Table 4: Device Status LEDs
Name
Color
State
Description
Power
Green
Steady
Indicates that the unit is
receiving power
Off
Indicates that the unit is
not receiving power
Status
Green
Off
Indicates that the system
is starting or is powered
off.
Blinking
Indicates that the device is
operating normally.
Alarm
Off
No alarm
Amber
Steady
Major alarm:
 Low memory (less than
10% remaining).
 High CPU utilization
(more than 90% in use).
 Session full.
 Maximum number of
VPN tunnels reached.
 HA status changed or
redundant group
member not found.
Red
Steady
Critical alarm:
 Failure of hardware
component or software
module.
 Firewall attacks
detected.
HA (High
Availability)
Green
Steady
Unit is the primary
(master) device.

Juniper SSG 520M Specifications

General

Brand	Juniper
Model	SSG 520M
Category	Gateway
Language	English