10
ENA 7
k T Press the Rotary Switch to confirm the setting.
OK, the water hardness is set.
HARDNESS
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY
Adjusting the grinder
You can adjust the grinder on a continuous scale to
suit the degree of roast of your coffee.
CAUTION
If you adjust the consistency of grind when the
grinder is not operating, the grinding wheel could
be damaged.
T Only adjust the consistency of grind when
the grinder is running.
The consistency of grind setting is correct if the
coffee flows regularly from the coffee spout.
In addition a fine, thick crema forms.
Example: Change the consistency of grind during
the preparation of an espresso.
T Place a cup under the coffee spout.
< T Press the Espresso button to start prepara-
tion.
T Turn the grinding wheel to the desired
position while the grinder is running.
1 ESPRESSO, the preset amount of
water flows into the cup and preparation
stops automatically.
READY
2 Preparation
You can stop the machine at any time while E
a coffee speciality or steam for cappuccino is
being prepared. Just press any button.
Before and during the grinding operation
E
you can select the coffee strength of
‘1 espresso’ and ‘1 coffee’:
MILD,
NORMAL, STRONG.
During preparation, you can change the
E
preset amount of water by turning the
Rotary Switch.
You can follow the current status of
E
preparation on the progress bar.
You can make permanent settings for all products
in programming mode (see Chapter 4 ‘Permanent
settings in programming mode – Products’).
Espresso and coffee
The preparation of ‘1 espresso’ and ‘1 coffee’ always
follows this model.
Example: Prepare one coffee.
Precondition:
READY is displayed.
T Turn the coffee spout to the ‘1 cup’ position.
T Place a cup under the coffee spout.
> T Press the Coffee button to start preparation.
1 COFFEE, the preset amount of water
flows into the cup.
Preparation stops automatically.
READY
To Next Page
Loading...
