EasyManua.ls Logo

Jura ENA 7 - Rinsing the Cappuccino Frother

Jura ENA 7
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
ENA 7
Precondition: DE-SCALE / READY is
displayed.
T Open the cover behind the Rotary Switch.
c T Press the Maintenance button.
EMPTY TRAY
T Empty the drip tray and coffee grounds
container and reinsert them.
AGENT IN TANK
T Remove and empty the water tank.
T Completely dissolve the contents of one
blister (three JURA descaling tablets) in a
receptacle holding 500 ml of water. This
may take several minutes.
T Pour the solution into the empty water tank
and reinsert the tank.
OPEN TAP
T Carefully pull the cappuccino frother off the
Connector System
©
.
T Place a receptacle (at least 500 ml) under the
Connector System
©
.
l T Turn the switch anticlockwise to position m.
DE-SCALING, water flows out of the
Connector System
©
several times.
CLOSE TAP
y T Turn the switch clockwise to position o.
DE-SCALING, the descaling operation
is continued.
EMPTY TRAY
T Empty the drip tray and coffee grounds
container and reinsert them.
T Empty the receptacle and place it back
under the Connector System
©
.
FILL WATER TANK
T Remove the water tank, rinse thoroughly, fill
with fresh, cold water and reinsert.
OPEN TAP
l T Turn the switch anticlockwise to position m.
DE-SCALING, water flows out of the
Connector System
©
.
The operation is interrupted,
CLOSE TAP.
y T Turn the switch clockwise to position o.
DE-SCALING, the descaling operation
is continued.
EMPTY TRAY
T Empty the drip tray and coffee grounds
container and reinsert them.
READY
T Reattach the cappuccino frother to the
Connector System
©
.
If the descaling operation stops unexpect- E
edly, rinse the water tank thoroughly.
Rinsing the cappuccino frother
This chapter applies to the E Professional and
Easy Cappuccino Frothers.
To ensure that the cappuccino frother always works
properly, you should rinse it with water after every
milk preparation. Your ENA will not prompt you to
rinse the cappuccino frother.
T Remove the milk pipe from the milk carton
or the milk container.
T Fill a receptacle with fresh water and
immerse the milk pipe in the water.
T Place another receptacle under the
cappuccino frother.

Table of Contents

Other manuals for Jura ENA 7

Related product manuals