13
ENA 7
If you are using the E Professional Cappuc-
cino Frother, set the selector switch to the
Milk Foam position p.
n T Press the Steam button.
HEATING
As soon as the ENA has heated up, READY
appears again.
l T Turn the switch anticlockwise to position m.
STEAM, the milk foam is prepared.
y T Turn the switch clockwise to position o
when there is sufficient milk foam in the cup.
You can continue to prepare steam for the
E
next 40 seconds or so without the machine
having to heat up again.
T Place a cup under the coffee spout.
< T Press the Espresso button to start prepara-
tion.
1 ESPRESSO, the preset amount of
water flows into the cup.
Preparation stops automatically.
To make sure the cappuccino frother always works
properly, it should be rinsed and cleaned regularly
(see Chapter 5 ‘Maintenance – Rinsing the cappuc-
cino frother’).
Hot milk and milk foam
This chapter applies to the E Professional and
Easy Cappuccino Frothers.
Example: Proceed as follows to prepare milk foam.
Precondition:
READY is displayed.
T Take the protective cover off the cappuccino
frother.
T Attach the milk pipe to the cappuccino
frother.
T Insert the other end of the milk pipe into a
milk carton or connect it to a milk container.
T Place a cup under the cappuccino frother.
If you are using the
E Professional Cappuc-
cino Frother, set the selector switch to the
Milk Foam position p.
If you want to
E heat the milk, turn the
selector switch of the frother to the Milk
position t.
n T Press the Steam button.
HEATING
As soon as the machine has heated up,
READY appears.
l T Turn the switch anticlockwise to position m.
STEAM, the milk foam is prepared.
y T Turn the switch clockwise to position o
when there is sufficient milk foam in the cup.
You can continue to prepare steam for the
E
next 40 seconds or so without the machine
having to heat up again.
To make sure the cappuccino frother always works
properly, rinse and clean it regularly (see Chapter 5
‘Maintenance – Rinsing the cappuccino frother’).
Cappuccino with the 2-stage frothing
nozzle
Precondition: READY is displayed, the coffee
spout is set to the ‘1 cup’ position.
T Push the 2-stage frothing nozzle to the
lower position.
en
To Next Page
Loading...
